Protective Wing Mats

FJORD AVIATION PRODUCTS wing mats are made of high impact absorbing non-abrasive urethane polymer and are chemical and fuel resistant and flame retardant with operating temperatures from
–20° to 200°F.

Sizes:
18” wide x 24” long (part# AFP-1824), weighs approx 3lbs

18” wide x 36” long (part# AFP-1836), weighs approx 4lbs

Both have a service port about 5 inches in diameter

Colors:  Red, Light Blue, Royal Blue, Yellow, Green, Orange, Black

Features include 1 side that is smooth and shiny and somewhat sticky (place this side directly on the wing) to reduce sliding or blowing off the wing and the other “top” side (stated on 2 areas of the mat THIS SIDE UP) is textured and dull for protecting the nozzle and hose from sliding and slipping causing possible damage. The ease of rolling the wing mat up and fitting it inside the aircraft or cab of the refueling truck for storage and /or transporting is another great feature.

Why settle for “bar mats or “tear away” mats when you can have the best protection for the wing of your aircraft for years, if properly
maintained (2 year warranty), instead of “one time fueling mats” with our AFP-1824 or AFP-1836 wing mats

Our care and maintenance sheet is available below

 

All weather breather cap

Protective Wing Mats

Protective Wing Mat
AFP-1824 and AFP-1836
for Aircraft Fueling and Engine Access

 

AFP-1824 & AFP-1836 WING MAT
Care and Maintenance Sheet

 Our AFP Series (Aircraft Fuel Protective & Engine Access) wing mat is the finest product of its kind in today’s industry.
They are the result of an engineering study of more than forty-four over-the-wing fueled aircraft and are made from the
finest grade of impact absorbing urethane and elastomer. Designed to fit and protect the aircraft wing surface from fuel
as well as nozzle and hose damage.  The unique quality of this type of polyurethane, will give many years of trouble free
service (est. operating life 5 years – warranty 2 years except for color change.)

Important:
The wing mat is shipped with a silicon spray covering to keep it from sticking together with other mats during manufacturing,
storage and transportation. Simply wash the mat with liquid soap and water and dry. You will notice the mat becomes sticky
which is a normal characteristic of the material.

Operation:
Place the mat on the wing over the fuel loading port and the words, “This Side Up”, facing upwards. This is to allow the smooth
side to seal to the wing surface. In damp or wet weather, the mat will stick to the wing surface even better. To remove the mat
from the wing surface, simply pull-up and peel- off from any corner.

Maintenance & Care:
 The AFP Series wing mat is virtually maintenance free and is impervious to dust, dirt, fuels as well as ultraviolet rays and most
chemicals (except MEK). However if the mat is exposed to sunlight on a continual basis, color fading/change will occur.
(This color change will not affect the working properties of the mat – ONLY the color.) Therefore we suggest that after
fueling is completed, the mat should be wiped off, rolled up and stored in the refueling cab
or an enclosed compartment or
container.
Do not hang mat on hooks, valves or such apparatus around the refueling truck – this may result in damaging the
mat. For best results to clean the mat, wash with liquid soap and water.  Rinse well and dry off with a towel. Do not coat mat with
silicon or WD-40 or such products, this will cause dust and dirt to collect and could scratch the wing surface.