FJO-29594 and FJO-94S

FJORD AVIATION PRODUCTS FJO-29594 is a Secondary Poppet Replacement Kit for the OPW 295 Nozzles. This kit comes with a METAL Secondary Poppet with a replaceable seal, a mounting pin and a new o-ring (no stem shaft)

Why replace the stainless stem and poppet and the poppet gasket when only the poppet goes bad. This poppet is permanent and made of aluminum, not plastic, and has a replaceable seal the FJO-94S so that if the seal wears out you can purchase a new seal and replace it.

See replacement instructions below.

 

 

 

 

 

All weather breather cap

FJO-29594 and FJO-94S

FJO-29594 Secondary Poppet Replacement Kit
for the OPW 295 Nozzles
FJO-94S Poppet Replacement Seal

Removing the Original Poppet Step 1

1. Remove the pin from the poppet by driving out the pin with a small punch or hammer.

Removing the Original Poppet Step 2

2. Once the pin has been removed slide the poppet and o-ring from the stem.

Installing the New Poppet and O-ring Step 1

1. Take the new
o-ring from the kit, lube it and slide it on the stem, next take the new poppet from the kit and slide it over the stem and on top of the o-ring.

Installing the New Poppet and O-ring Step 2

2. Align the hole in the new poppet with the hole in the stem.

Installing the New Poppet and O-ring Step 3

3. Take the new shaft pin from the kit, insert it and tap it in place until it is flush with both sides.

Installing the New Poppet and O-ring Step 4

4. Replacement is now complete.

Fjord Aviation Products

Your trusted source
for the delivery of
dry, clean fuel

Address

306 Anders Lane
Kemah, Texas 77565

Get in Touch

281-334-4228

800-880-3535